|
Screw
Mount Installation Guide
1.
Get the Mechanical Drawing
You can get the mechanical drawing of your product model from
specification. If you can’t find the correct mechanical drawing,
please contact us.
2. Make the cut out
There is the cutout dimension on the Mechanical Drawing. Make
sure your cutout match the cutout dimension requirement. If
the cutout is too small, there will be some interference. If
the cut out is too big, you can’t have the screw holes at correct
position.
3 Drill the screw holes
You have to drill the screw holes on your mounting wall for
mounting the panel. You can find the position of the screw holes
on the mechanical drawing.
Make sure the position of the screw holds correctly match the
position on the mechanical drawing, otherwise you won’t be able
to install the screws. The best way to mount the panel is to
align the bottom of the panel housing with the bottom edge of
the cut out. This way can help hold the panel steadily.
Front Side of the Mounting Wall
Back
Side of the Mounting Wall
4.
Prepare the accessory
For screw mount installation, you need to prepare the correct
screws and screw driver by yourself. Make sure the length
and the diameter of the screws are correctly fit the requirement.
Because the maximum depth of the standoff on the panel is
4 mm, the length of your screw got to be the thickness of
your mounting wall + 4 mm. With the correct length screw can
ensure the mounting of the panel tightly & securely.
5.
Installation
- Fit the panel in the cut out from the front side of the
mounting wall.
- Adjust the position of the panel to fit all the screw holes
position properly.
- At the back side of the mounting wall, screw the screw through
the screw hole to mount the panel tightly.
- Finish all the screws mounting one by one then you can have
a secure installation for your Panel Mount product. See Fig.
2.
Clamp
Mount Installation
1. Get the Mechanical Drawing
You can get the mechanical drawing of your product model from
our specification. If you can’t find the correct mechanical
drawing, please contact us.
2. Make the cut out
There is the cutout dimension in the Mechanical Drawing. Make
sure your cutout meet the cutout dimension requirement. If the
cutout is too small, there will be some interference. If the
cutout is too big, you can’t have the clamps mounting securely.
Please note that there is thickness limitation of the mounting
wall for clamp mount installation. The mounting wall thickness
limitation for greater than 24” panel is 20 mm. For those panels
equal to or smaller than 24”, it is 12 mm.
3. Prepare
the accessory
For clamp mount installation, you will receive at least 8
clamps and screws together with your unit and you have to
prepare the screw driver by yourself. There are at least 2
clamps for each side of the panel. The clamp looks as the
below picture. The clamp and the screw are paired.
4.
Installation
- Fit the panel in the cut out from the front side of the mounting
wall.
The best way to mount the panel is to align the bottom of the
panel housing with the bottom edge of the cut out. ( as Fig.
2) This way can help hold the panel steadily.
- At the back side of the mounting wall, insert the clamp into
the slide hole at the side bracket on the panel.
- Fit the screw
on the clamp and screw it tightly.
- Finish all the
clamps mounting one by one then you can have a secure installation
for your Panel Mount product.
|
